Beko BUDL 700 Specifications download pdf (Page 15)

Start up

DRYPOINT

RS 15 – 1700 HP50 NA 15

3.3. Start-up and shut down

3.3.1. Marcia ed arresto DRYPOINT RS 15- 450 HP50 NA

Start-up (refer to paragraph 5.1 Control Panel) :

•

Check the condenser for cleanliness (Air-Cooled).

•

Ensure the cooling water flow and temperature is adequate (Water-Cooled).

•

Verify that the system is powered.

•

Activate the main switch - pos. 1 on the control panel.

•

Ensure that electronic controller is ON.

•

Wait a few minutes; verify that the DewPoint temperature displayed on electronic instrument is correct and that the

condensate is regularly drained.

•

Switch on the air compressor.

Shut down (refer to paragraph 5.1 Control Panel) :

•

Verify that the DewPoint temperature displayed on electronic controller is correct.

•

Switch OFF the air compressor.

•

After a few minutes, switch off the main switch on the control panel of the dryer (pos. 1).

NOTE : DRYPOINT RS 15-40 HP50 NA - A DewPoint included in the green operating area of the electronic controller

is correct according to the possible working conditions (flow-rate, temperature of the incoming air, ambient

temperature, etc.)

NOTE : DRYPOINT RS 50-450 HP50 NA - A DewPoint within 32°F (0°C) and 50°F (10°C)displayed on the electronic

controller is correct according to the possible working conditions (flow-rate, temperature of the incoming air, ambient

temperature, etc.).

During the operation, the refrigeration compressor will run continuously. The dryer must remain on during the full usage

period of the compressed air, even if the air compressor works intermittently.

The number of starts must be no more than 6 per hour. The dryer must stop running for at least 5

minutes before being started up again.

The user is responsible for compliance with these rules. Frequent starts may cause irreparable damage.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 67 68

No comments

Beko BUDL 700 Specifications Page 15