Beko WMD 25085 T Specifications download pdf (Page 9)

9 - EN

or lower temperatures. You must cancel

the ongoing program in order to change the

washing program.

For example, press and hold the “Start/Pause/

Cancel” button for 3 seconds in order to select

“Cottons 40” program instead of “Cottons 60”

program. Select the “Cottons 40” program.

Start the program.

Switching the machine to standby

mode

Press “Start/Pause/Cancel” button

momentarily to switch your machine to the

standby mode. Auxiliary functions can be

cancelled or selected in accordance with

the step the program is at. The door can be

opened if the water level is suitable. Laundry

may be added / taken out by opening the

door.

Child-proof lock

You can protect the appliance from being

tampered by children by means of the child-

proof lock. In this case, no change can be

made in the running program.

The machine is switched to child-lock by

pressing the 1st and 2nd auxiliary functions

from the left for 3 sec. 1st auxiliary function

light will flash continuously. To deactivate the

child-proof lock, press the same buttons for

3 sec.

Ending the program through

canceling

In order to cancel the selected program,

press the "Start/Pause/Cancel" button for

3 seconds. You can select and start a new

program when the “Ready” light is lit.

The “Spin” light illuminates if the cancellation

process is activated in the middle of the

program and the machine can either drain all

the water or can take in water 3 times at most

to cool down the clothes and perform the

draining process.

The program which is selected first will keep

on going even if the position of the program

selection button is changed. A new program

can be selected or started after “Program is

cancelled” in order to change the washing

program.

End of program

The “Ready” lamp on the program follow-up

indicator will light up when the program comes

to an end. The door can be opened and the

machine is ready for a second cycle now.

Press the “On/Off” button to shut down the

machine.

5 Maintenance and cleaning

Detergent Drawer

Remove any powder residue buildup in the

drawer. To do this;

1. Press the dotted point on the siphon

in the softener compartment and pull

towards you until the compartment is

removed from the machine.

C

If more than a normal amount of water

and softener mixture starts to gather in

the softener compartment, the siphon

must be cleaned.

2. Wash the dispenser drawer and the

siphon with plenty of lukewarm water in

a washbasin.

3. Replace the drawer into its housing

after cleaning. Check if the siphon is in

its original location.

Inlet water filters

There is a filter at the end of each water intake

valve at the back side of the machine and also

at the end of each water intake hose where

they are connected to the tap. These filters

prevent the foreign substances and dirt in the

water to enter into the machine. Filters should

be cleaned as they get dirty.

• Close the taps.

• Remove the nuts of the water intake

hoses to clean the surfaces of the

filters on the water intake valves with an

appropriate brush.

• If the filters are very dirty, you can pull

them out by means of pliers and clean

them.

• Take out the filters on the flat ends of

the water intake hoses together with

the gaskets and clean thoroughly under

streaming water.

• Replace the gaskets and filters carefully

to their places and tighten the hose

nuts by hand.

Downloaded From WashingMachine-Manual.com Manuals

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 47 48

Comments to this Manuals

No comments