Beko UL584AP Instruction Manual download pdf (Page 9)

EN

9

3. Fit the two plastic wall spacer

supplied with the appliance on to

the condenser at the back of the

refrigerator by rotating 1/4 turn (see

diagram).

4. The appliance should be located

on a smooth surface. The two front

feet can be adjusted as required. To

ensure that your appliance is standing

upright adjust the two front feet, by

turning clockwise or anti-clockwise,

until the product is in firm contact with

the floor. Correct adjustment of feet

avoids excessive vibration and noise.

5. Refer to “Cleaning and Care” section

to prepare your appliance for use.

6. This appliance has been designed

to operate in ambient temperatures

between +10 and +32 degrees C (50

and 90 degrees F). Therefore if the

appliance is installed in an unheated

/ cold room (E.g.: Conservatory /

annex / shed / garage etc.) then the

appliance may not operate and as a

result the storage time of food may

be reduced.

7. A special receptacle is supplied to

store the mains plug during transit.

The receptacle is fixed at the back of

the cabinet, on the right hand side of

the compressor. (See diagram) Gently

remove the plug from the receptacle.

8. Never pull the mains cord, you may

damage the appliance. In the case

of transportation, ensure you locate

the plug in the receptacle provided

to avoid transit damage.The space

in the room where the appliance is

installed must not be smaller than 10

cubic metres.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Comments to this Manuals

No comments