Beko UL584AP Instruction Manual download pdf (Page 8)

EN

8

3 Installation

Transportation Instructions

1. The appliance should be transported

only in a vertical upright position. The

packing as supplied must be intact

during transportation.

2. If during the course of transport the

appliance has to be transported

horizontally, it must only be laid on its

right hand side when standing in the

front of the appliance. After bringing

it to upright position,it must not be

operated for at least 4 hours to allow

the system to settle.

3. Failure to comply with the above

instructions could result in damage

occuring to the appliance. The

manufacturer will not be held

responsible if these instructions are

disregarded.

4. The appliance must be protected

against rain, moisture and other

atmospheric influences.

5. Empty any water in the drain

tray before moving see section

“Defrosting” and “Cleaning & Care”

for further information

IMPORTANT :

Make sure the plastic evaporating pan

at the back of the product collects

water properly.

IMPORTANT:

Care must be taken while cleaning

/ carrying the appliance to avoid

touching the bottom of the condenser

metal wires at the back of theappliance

as you might injure your fingers and

hands.

IMPORTANT:

This appliance is not designed for

stacking with any other appliance.

When positioning your appliance, take

care not to damage your flooring,

pipes,wall coverings etc. Do not

move the appliance by pulling by the

door or handle.Do not attempt to sit

or stand on top of your appliance as

it is not designed for such use. You

could injure yourself or damage the

appliance.

IMPORTANT:

Make sure that mains cable is not

caught under the appliance during and

after carrying / moving the appliance,

to avoid the mains cable becoming cut

or damaged.”Do not allow children to

play with the appliance or tamper with

the controls.

BEKO declines to accept any liability

should the instructions not be

followed.

Installation Instructions

1. If possible avoid placing the appliance

near cookers, radiators or in direct

sunlight as this will cause the

compressor to run for long periods.

If installed next to a source of heat

or refrigerator, maintain the following

minimum side clearances:

From Cookers 2” (50 mm)

From Radiators 12” (300 mm)

From Refrigerators or Larder Fridge 1”

(25 mm)

2. No gap is required at sides and top.

See item 3 below to ensure a gap is

obtained at the rear of the appliance.

If a gap is available on side and

top, retain it if possible as it would

improve the air circulation around the

appliance.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Comments to this Manuals

No comments