Beko CS 58000 User Manual download pdf (Page 37)

Part Important Installation and preparation of your oven

Before your opplionce is connected to the

mains electricity supply check to ensure that

the voltage and the frequency shown in the

data plate corresponds with your power supply.

The data plate is situated back cover of the

oven, or it is situated in the front of the storage

compartment and can be seen by opening the

storage compartment cover or pulling the drawer.

Warning!

This appliance must be earthed

Our company shall not held responsible for any

damage caused by the utilisation of the oven

without ground socket.

Before applying to Authorized service, have

the electrical wiring of your home ready for

connection.

If the appliances is connected by a plug, that

the plug is easily accessible after installation

(but not above the hob)

^^This product must only be installed by a

qualified electrician eg. local electricity company

to a suitable double pole control unit with a

minimum contact clearance of 3 mm in all poles

which should be adjacent to (but not above)

the cooker in accordance with lEE regulation.

Failure to observe this instruction may result in

operational problems and invalidation of the

product warranty. If the appliance is connected

by a plug, that the plug is easily accessible

after installation (but not above the hob).

The cable length should be 2 mt max hr isolation

safety.

In models writh "small type- terminal block'"

In mix models a cable supplied with a plug with

your oven (H05 V V-F 3G 1.5 mm2)

^ if a coble without a plug is provided together

with your oven (H05 V V-F 3G 2,5 mm2 )

Take care to connect as below:

Brown coble = L (Live)

Blue coble = N (Neutral)

Green/Yellow cable = E (Earth)

If your oven is supplied without supply cord use

schemo-l to choose supply cord and use sc he mo

ll for installation of cord.

The cable length should be max 2m long for

isolation safety.

^Open the terminal block cover.

^Connect the supply coble according to wiring diagram on the rear

cover.

Fix the supply coble to main body with integrated screw via cable

tightener.

^ Assembly the terminal block cover to its place.

Your oven is suitable for single and three phase connection.

^The mains coble must pass through the coble clomp.

^The mains cable should be routed away from the appliance and ...

particular ventilation slots, the vent outlet and should not be obstructed when

Connection Type

Monophase Three phase

with Neutral

Two phase

with Neutral

Voltage

220/230/

240 V

380/400/

415 V

380/400/

415 V

Supply cord type

(max 2m long)

3x2,5 mm2

H05 V V-F

5x2,5 mm2

H05 V V-F

4x2,5 mm2

H05 V V-F

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 71 72

Comments to this Manuals

No comments

Beko CS 58000 User Manual Page 37

Comments to this Manuals

Related products and manuals for Stoves Beko CS 58000