Beko TSE1241 Instruction Manual download pdf (Page 17)

en en

Transport instructions

The appliance should be transported only in

upright position.

The packing as supplied must be intact during

transportation.

f the appliance is transported in the horizontal

position, it must be placed vertically and left

in this position for 4 hours before taking into

operation.

The appliance must be protected against rain,

moisture and other atmospheric influences.

The manufacturer assumes no liability if safety

instructions are disregarded.

Disposal

Make the appliance unusable immediately.

Pull out the mains plug and cut the power

cable. Remove or destroy snap or latch locks

before disposing of the appliance. In this

manner you prevent children from locking

themselves in and endangering their lives.

Appliance setup

• Do not operate your appliance in a room

where the temperature is likely to fall below

10 °C at night and/or especially in winter. At

lower temperatures the appliance may not

operate, resulting in a reduction in the storage

life of the food.

• The climate class rate of your appliance is

given on the rating label located inside the

appliance. It specifies the appropriate operating

ambient temperatures as explained below.

Climatic class Ambient temperatures

SN.......................+10 °C to 32 °C

N .........................+16 °C to 32 °C

ST .......................+18 °C to 38 °C

T..........................+18 °C to 43 °C

SN-ST.................+10 °C to 38 °C

SN-T ...................+10 °C to 43 °C

Location

Only place the appliance in dry rooms which

can be ventilated.

Avoid direct sunlight or direct heat sources

such as a stove or a heater.

If this cannot be avoided, the following

minimum distances should be maintained:

Electric stoves: 3.00 cm

Heater: 3.00 cm

Cooling devices: 2.50 cm

• Make sure that sufficient room is provided

around the appliance to ensure free air

circulation.

•Depending on the model of your product, two

plastic wall spacers or a back air grille is

supplied with your appliance.

If your appliance is equipped with an air grille,

please refer (Fig. 2 a) for installation of the air

grille.

If your appliance is equipped with two plastic

wall spacers, fit the spacers by rotating 1/4

turn to the condenser at the back of the

appliance (Fig. 2 b).

• The appliance should be located on a level

surface. The two front feet can be adjusted as

required. To ensure that your appliance is

standing upright adjust the two front feet by

turning clockwise or counter-clockwise, until

the product is in firm contact with the floor.

Correct adjustment of feet avoids excessive

vibration and noise.

Electrical connections

Warning

This appliance must be grounded.

• Check whether the power type and voltage your

region corresponds to the one stated on the rating

label inside the appliance.

• The electrical safety of the appliance is only

assured when the grounding system in the house

is installed in accordance with regulations.

• When placing the appliance, do not let the

power cable get stuck under it; otherwise the

cable will be damaged.

• Ensure that the plug remains readily accessible.

Do not use a multiple adapter bar or an extension

cable.

• The electrical specifications of your appliance

is given on the rating label located inside the

appliance.

• Route power cable to allow easy connection

and disconnection after installation.

• If the supply cord is damaged, it must be

replaced by the manufacturer, its service agent

or similarly qualified persons in order to avoid a

hazard.

• A contact separator should be used if the power

cable is not accessible. (for built-in models)

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 44 45

Comments to this Manuals

No comments

Beko TSE1241 Instruction Manual Page 17

Comments to this Manuals